Available in packs of 1 to 3 - This product is designed for a wide variety of applications where two pieces of plastic tube or hose need to be connected together and the flow needs to be adjusted or turned off. The size stated refers to the internal diameter of the hose. Available in Black or White - please message us if you would prefer a specific colour. This product has been tested over many years. Please also see our range of plastic/metal clamps.
Plastic Inline Hose Taps / Valves
These tough plastic, barbed in-line taps are made from POM (Polyoxymethylene). They are suitable for a wide range of liquid and gas applications, where flow needs to be controlled.
NOTE - These taps are designed to fit inside standard size PVC tube. The size stated 'To Fit Hose I.D.' (Internal Diameter) is the tube size (bore) that the taps are designed to fit inside - e.g. if you have 10mm I.D. Tube, then you need to order a 10mm tap. The barbs on the tap are larger than the tube size to ensure a tight fit. For some applications tube clamps may be required.
Example uses include Garden Water Projects, Engineering, Water, Air & many other DIY uses. (It is the customers responsibility to ensure suitability and safety of use).
* Large Handle Grip for Easy Use
* Very Hard Wearing, Stable Plastic Properties - Long Life
* Good Temperature Range (-20 to +60 degrees C)
* Good UV Resistance
Please note the 16mm, 19mm & 25mm taps have a bore reduction at the valve, please see the table below for full fitting dimensions and other data. The images are an accurate representation and shows all sizes listed.
The image within this page is copyrighted by © PVC Tube Online Ltd.